IC TDA2002 amplifier circuit diagram 8W

amp-TDA2002-Single

IC TDA2002 amplifier circuit diagram 8W, this is a class AB audio power amplifier circuit which built using a TDA2002 or TDA2003 power amplifier IC module. These are replacements for the original LM383, which is no longer available. It is easy to build and has a minimum of external components. The module has both short circuit protection and thermal protection. It can drive loads as low as 1.6 ohms and is capable of delivering over 10 watts from a 16 V supply.

The TDA2002 and TDA2002A are integrated circuit amplifiers specially designed for use in car radios, where the adverse electrical environment places great demands upon the reliability of circuits.

The supply voltage may be anywhere between +8 and +18V, and the IC will accept transient voltage peaks of up to 28V without damage. The IC can supply a short-circuit output current of 3.5 A and 15W of power at a case temperature of 90 °C. At a supply voltage of 14.4V (fully charged battery) the maximum output power is at least 4.8W, and typically 5.2W into a 4 Ω load.

Get new posts by email:

The IC will, in fact, drive load impedance’s as low as 2 Ω, in which case the maximum output power is at least 7W and typically 8W. The above power are all measured at 10% distortion, but obviously at lower output powers the distortion is much less (Typically 0.2%).

Specifications:

  • C. Input: 8 – 18V, 10 – 20 VA min.
  • Power output:
    • > 10 W RMS, 2 ohm load, 16V DC supply.
    • > 6W RMS, 4 ohm load, 16V DC supply.
    • > 4W RMS, 4 ohm load, 12V DC supply.
  • THD: < 0.2% (1W, 4 ohm load) Gain: 40 dB maximum. S/N ratio : > 80 dBA. (G = 20 dB) > 60 dBA (G = 40 dB)
  • Frequency response: < 20 Hz to > 40 kHz (-3dB, 4 ohm load)
  • Input level:
    • < 100 mV for full output (G = 40 dB)
    • < 1V for full output(G = 20 dB)

Schematic diagram of the audio power amplifier tda2002

Schematic Diagram Of The Audio Power Amplifier Tda2002
Schematic Diagram Of The Audio Power Amplifier Tda2002

Suggestion for PCB amplifier circuit TDA2002

Printed Circuit Board Pcb Ic Tda2002 Amplifier Circuit Diagram 8W
Printed Circuit Board Pcb Ic Tda2002 Amplifier Circuit Diagram 8W
Printed Circuit Board Pcb Component Silk Ic Tda2002 Amplifier Circuit Diagram 8W
Printed Circuit Board Pcb Component Silk Ic Tda2002 Amplifier Circuit Diagram 8W
Printed Circuit Board Pcb Component View Ic Tda2002 Amplifier Circuit Diagram 8W
Printed Circuit Board Pcb Component View Ic Tda2002 Amplifier Circuit Diagram 8W

List of material to assemble the mono power amplifier

Last update: 09/08/2021 20:13

Part Value Description Quantity
Capacitors
C1, C5 470uF/25V Electrolytic capacitor 2
C2 100nF Ceramic Capacitor 1
C3 10uF/16V Electrolytic capacitor 1
C4 39nF Polyester Capacitor 1
C6 1000uF/25V Electrolytic capacitor 1
C7 100nF Polyester Capacitor 1
Semiconductors
IC1 TDA2002 Audio amplifier integrated circuit. 1
Resistors 1/4W
R1 39 ohms Orange, white, black, gold 1
R2 220 ohms Red, red, brown, gold 1
R3 2.2 ohms Red, red, brown, gold 1
R4 1 ohm 1W Brown, black, gold, gold 1
Miscellaneous
P1 10K (103) Potentiometer 1
CN1 IN Jst Xh 2-Way Connector 2.54 mm pitch 1
CN2 DC Terminal block 2 pin 5.08 mm 1
CN3 OUT Terminal block 2 pin 5.08 mm 1
Solder, Wires, PCB, Box, Power Supply, etc.

For more information about the tda2002 integrated circuit, see the datasheet!

Download the PDF, PNG, postscript and Gerber plates for the Amplifier Circuit.

Download    

Mirror

Download the PDF Datasheet of IC TDA2002

This IC can be found as TDA2002H, TDA2002V, UPC2002

 

How useful was this post?

Click on a star to rate it!

Average rating / 5. Vote count:

No votes so far! Be the first to rate this post.

As you found this post useful...

Share on the social networks!

We are sorry that this post was not useful for you!

Let us improve this post!

Tell us how we can improve this post?

Photo of author
About the author
Xtronic.org blog author. Electronics technician for the technical school of Brasilia - Brazil. Interested in electronics, circuits and technology in general.
Share:

12 thoughts on “IC TDA2002 amplifier circuit diagram 8W”

  1. Could you please post/send the file design of this litle project? it would be really usefull. Thanks.
    davedicius-at-gmail.com

    Reply

Leave a Reply to jean Cancel reply